Cords & Cables Locators , Fault Detectors

Cords & Cables Locators , Fault Detectors :

LKZ-2000 :

Sonel LKZ-2000 system has a unique flexible operating modes to help you easily decide the right mode for your locating application and site conditions. The intelligent utility locator monitors the signal interference levels in all available modes and recommends which to use for the best results. Saving you time and giving you increased confidence in your results.

LKZ-1500 :

The LKZ-1500 set for underground utility localization, consisting
of a transmitter and receiver, allows you to locate, identify and track the route of buried objects in the ground

LKZ-1500 LITE :

Cable routing without secrets with the LKZ-1500-LITE

The Sonel LKZ-1500-LITE cable and wire locator is a set, consisting of a transmitter (LKN) and a receiver (LKO), which allows finding, identifying and tracing the route of objects buried in the ground. It is an indispensable piece of equipment for energy and installation companies dealing with a wide range of earthworks.

LKZ-1000 :

Passive or active modes of tracing, detection of underground live wires, detection of underground wires with no voltage (radio mode), detection of underground wires with no voltage using a transmitter (galvanised, inductive or clamp-based connection), tracing metallic or non-conductive pipes using an additional probe, tracing non-conductive pipelines using a “floating” probe, tracing a determined cable and determining the depth of a cable.

LKZ-720 :

Detection of wires and cables (live or not), identification of fuses on the distribution board, tracing underground cables, tracing conductive water and heating pipelines and non-contact detection of live cables.

LKN-720 :

Locating power points and switches in buildings

pulse generated by a LKN-720 transmitter with a specific frequency allows to locate and identify sockets and switches in energized and de-energized circuits.

LKO-720 :

In response to the needs of customers, the LKO-720 has a specially designed 3D antenna that raises the precision of the wire tracing. Determine direction of wires in concrete up to 5 cm will not be a problem now.

TDR-420 :

TDR-420 is a hand held Time Domain Reflectometer designed to identify and locate faults in power, telecommunications and teletechnical cables, TDR-420 reflectometer allows to measure the length of the cable and determine the distance to damage or impedance variation in the range of 4 m to 6000 m in conductors with metal wires, the shortest measuring range of 7 meters and a dead zone of 0.6 meters allows to locate damages at a very close distance from the place where the device is connected.

TDR-410 :

Location damaged power cables, fault location copper telecom cables, coaxial cable fault location, fault location wiring infrastructure, detection of breaks, short circuits, damage caused by dampness and other changes in impedance of the cable, graphic depiction of damage the cable with automatic indication the distance to fault on the screen.